Jump to content

Unofficial Home of Old Simplicity & Allis-Chalmers Garden Tractors

Sign in to follow this  
buckfollwr

Hydraulic whine!

Recommended Posts

buckfollwr
?I have a 9020 that has a loud whine whenever you use the hydraulics. If anyone has had this problem any insight will help. I am leaning towards a restiction prior to fluid going into the valve. I feel this because it does not whine whenever driving until you try to use either hydraulic lever. Any help is appreciated.

Share this post


Link to post
Share on other sites
Leroy
Whinning is prevalent on many hydros I personally think it has more to do with air entraption then anything else If air gets into the pump or water they compress at different rates. Bad bearings can and do whine even when they are submerged. Old washing machines are a good example. Water gets down the spin tube via bad seals and displaces the oil. displaced oil will appear as a leak but in reality the water is pushing it out.

Share this post


Link to post
Share on other sites
Hoss
I had that whining problem on my Sunstar. I first changed the filter but the whining stopped after only I changed the hydro fluid. You should try that if it hasn't been done in a while.

Share this post


Link to post
Share on other sites
Guest
This topic is now closed to further replies.
Sign in to follow this  

  • Who's Online (See full list)

    • s_stephen
    • John Dyer
    • SmilinSam
    • Cityboy
    • rokon2813
    • DaveBsACs
    • stans17
  • Today's Birthdays

    No users celebrating today
  • Recent Status Updates

    • jbrooks

      jbrooks  »  Talntedmrgreen

      Josh
       
      folowing  this from a link at the downloads.  I just rescued an AC 920 with the lambodini diesel. I can' t download  yet .  Where did you find the PDF copy you posted. . I would like to figure out how to adjust the injection pump. 
      I assume it's a bosche, correct
      · 0 replies
    • dav-1

      dav-1  »  Talntedmrgreen

        Over a year ago, you answered a question I had about the tool bar for my FDT. In your reply dated Dec 31, 2019  you said the spacer, part #16, goes in the bar to allow for up and down depth adjustment. does this mean the bolt has to be tightened at whatever depth desired or does the bolt slide up and down, allowing the lower hitch to free float?
         If it is tightened so the lower hitch and the bar are rigid, then is the depth to be controlled by the shoes? Or by the lift handle?
        Is there any kind of user directions for the tool bar? The Outdoor Power Manual basically shows how to assemble the bar but not how to use it
      · 1 reply
  • Adverts

×