Jump to content

Unofficial Home of Old Simplicity & Allis-Chalmers Garden Tractors

Sign in to follow this  

Kohler 10amp Regulator

Recommended Posts

The charging system on the HB-916 (916H) is not working. Checked the output of the alternator, 36VAC. Good according to the manual. Says I need a new regulator/rectifier. I have the 10 amp 3 spade type. Looked it up at Jack's - $95 OUCH! I see cheaper one for different engines listed. Can I use another, cheaper type or is a $95 bill in my future? Guess I can keep putting it on the trickle charger periodically if need be. Brent

Share this post

Link to post
Share on other sites
This topic is now closed to further replies.
Sign in to follow this  

  • Who's Online (See full list)

    • OntBoy
    • Paul M.Murphy
    • D10-Allis
    • MRR
    • gwiseman
    • Sovereignm88
    • Hick
    • MARK (LI)
    • Chris727
  • Today's Birthdays

    1. dbulkley62
      (59 years old)
  • Recent Status Updates

    • jbrooks

      jbrooks  »  Talntedmrgreen

      folowing  this from a link at the downloads.  I just rescued an AC 920 with the lambodini diesel. I can' t download  yet .  Where did you find the PDF copy you posted. . I would like to figure out how to adjust the injection pump. 
      I assume it's a bosche, correct
      · 0 replies
    • dav-1

      dav-1  »  Talntedmrgreen

        Over a year ago, you answered a question I had about the tool bar for my FDT. In your reply dated Dec 31, 2019  you said the spacer, part #16, goes in the bar to allow for up and down depth adjustment. does this mean the bolt has to be tightened at whatever depth desired or does the bolt slide up and down, allowing the lower hitch to free float?
         If it is tightened so the lower hitch and the bar are rigid, then is the depth to be controlled by the shoes? Or by the lift handle?
        Is there any kind of user directions for the tool bar? The Outdoor Power Manual basically shows how to assemble the bar but not how to use it
      · 1 reply
  • Adverts