Jump to content

Unofficial Home of Old Simplicity & Allis-Chalmers Garden Tractors

Sign in to follow this  

How to wire electric lift ?- Need Help and Diagram

Recommended Posts

hi i am going to add an electric lift to one of my tractors - dose anyone know the basic setup of how to wire it or can someone make me a simple / basic diagram of the wiring hook ups ? - i have an electric lift with 2 wires , a battery , and a 15 amp double pole- double throw - temp. switch with 6 prongs , (on)off(on) , - i know that when i hook up the wires to the battery it goes one way and when i reverse them it goes the other - i dont know how to wire this into the switch and battery or is it run throught the recharging system somehow ? - also is the power for the electric lift just come off the battery only ? - is the only connections comming off the battery a pos. / neg. wires ? - the whole switch thing confuses me - need help - thanks alot

Share this post

Link to post
Share on other sites
Jason, go here. http://www.simplicitytechpubs.com/techpubsearch.php Type in and download 1690352 and 1690043. The first one is an operators manual and in the back of the book is an atypical wire diagram for a power lift and the second on is an atypical operators book for a lift ass'y. This might help you.

Share this post

Link to post
Share on other sites
You want to wire the pos. and neg. to one set of end terminals, then make short jumpers and wire them the opposite way to the other end terminals. They are the green and black wires shown on this OEM "Wire Harness and Switch", Part Number 1651166. The middle terminals go to the lift, the yellow and black wires shown here.

Share this post

Link to post
Share on other sites
This topic is now closed to further replies.
Sign in to follow this  

  • Who's Online (See full list)

    • Gary
    • a_sannine
    • rokon2813
    • dayardguy
    • MRR
    • Clarsmn
  • Today's Birthdays

    No users celebrating today
  • Recent Status Updates

    • jbrooks

      jbrooks  »  Talntedmrgreen

      folowing  this from a link at the downloads.  I just rescued an AC 920 with the lambodini diesel. I can' t download  yet .  Where did you find the PDF copy you posted. . I would like to figure out how to adjust the injection pump. 
      I assume it's a bosche, correct
      · 0 replies
    • dav-1

      dav-1  »  Talntedmrgreen

        Over a year ago, you answered a question I had about the tool bar for my FDT. In your reply dated Dec 31, 2019  you said the spacer, part #16, goes in the bar to allow for up and down depth adjustment. does this mean the bolt has to be tightened at whatever depth desired or does the bolt slide up and down, allowing the lower hitch to free float?
         If it is tightened so the lower hitch and the bar are rigid, then is the depth to be controlled by the shoes? Or by the lift handle?
        Is there any kind of user directions for the tool bar? The Outdoor Power Manual basically shows how to assemble the bar but not how to use it
      · 1 reply
  • Adverts