Jump to content

Unofficial Home of Old Simplicity & Allis-Chalmers Garden Tractors

Sign in to follow this  

hi low shifter

Recommended Posts

I picked up a Second land loard for parts. It has a Hi Low on it but the Shifter is missing. Is it possabale to buy or make the shifter ring. I think I could fabracate one if i'd ever sean one installed. the drawing in the instlation manual is not too clear.

Share this post

Link to post
Share on other sites
Do you have the bracket that the shift ring and handle mount on? That's likely the most complicated part. This shift ring was made by another club member, though the mounting bracket is original. [img]http://www.simpletractors.com/images/2_into_1/high-low.jpg[/img]

Share this post

Link to post
Share on other sites
Here's another view, taken when I was putting the Big Ten together out of pieces... [img]http://www.simpletractors.com/images/2_into_1/high_low2.jpg[/img]

Share this post

Link to post
Share on other sites
This topic is now closed to further replies.
Sign in to follow this  

  • Who's Online (See full list)

    • MRR
    • PhanDad
    • rokon2813
    • MARK (LI)
    • dayardguy
    • gwiseman
    • tadams
    • BruceH
  • Today's Birthdays

    1. Ole Settler
      Ole Settler
      (71 years old)
  • Recent Status Updates

    • jbrooks

      jbrooks  »  Talntedmrgreen

      folowing  this from a link at the downloads.  I just rescued an AC 920 with the lambodini diesel. I can' t download  yet .  Where did you find the PDF copy you posted. . I would like to figure out how to adjust the injection pump. 
      I assume it's a bosche, correct
      · 0 replies
    • dav-1

      dav-1  »  Talntedmrgreen

        Over a year ago, you answered a question I had about the tool bar for my FDT. In your reply dated Dec 31, 2019  you said the spacer, part #16, goes in the bar to allow for up and down depth adjustment. does this mean the bolt has to be tightened at whatever depth desired or does the bolt slide up and down, allowing the lower hitch to free float?
         If it is tightened so the lower hitch and the bar are rigid, then is the depth to be controlled by the shoes? Or by the lift handle?
        Is there any kind of user directions for the tool bar? The Outdoor Power Manual basically shows how to assemble the bar but not how to use it
      · 1 reply
  • Adverts