Jump to content

Unofficial Home of Old Simplicity & Allis-Chalmers Garden Tractors

Sign in to follow this  
pacer

carb rear disk

Recommended Posts

pacer
while I was mowing today thedisk at the rear of the carb fell out. Then the engine would only run with full choke on.I limped back to the barn, but don't see what should hold the disk in. Is thier a way to reattach the disk?

Share this post


Link to post
Share on other sites
rokon2813
Its just kinda pressed in there. put it back and take a prick punch and put some little "dimples" all the way around it and it will stay in another 20 years or so.

Share this post


Link to post
Share on other sites
BLT
It's a welch plug and I set them in by using a golf ball and hammer. Putting a dimple into the concave of the plug will force the plug out and tighten it into the groove, if the groove is not nicked up. BTW, you will need a new plug. Trying to reset an old one is nearly impossible.

Share this post


Link to post
Share on other sites
Guest
This topic is now closed to further replies.
Sign in to follow this  

  • Who's Online (See full list)

    • simplewrench
    • Bill725
    • gwiseman
    • tadams
    • lugnard
  • Today's Birthdays

    No users celebrating today
  • Recent Status Updates

    • jbrooks

      jbrooks  »  Talntedmrgreen

      Josh
       
      folowing  this from a link at the downloads.  I just rescued an AC 920 with the lambodini diesel. I can' t download  yet .  Where did you find the PDF copy you posted. . I would like to figure out how to adjust the injection pump. 
      I assume it's a bosche, correct
      · 0 replies
    • dav-1

      dav-1  »  Talntedmrgreen

        Over a year ago, you answered a question I had about the tool bar for my FDT. In your reply dated Dec 31, 2019  you said the spacer, part #16, goes in the bar to allow for up and down depth adjustment. does this mean the bolt has to be tightened at whatever depth desired or does the bolt slide up and down, allowing the lower hitch to free float?
         If it is tightened so the lower hitch and the bar are rigid, then is the depth to be controlled by the shoes? Or by the lift handle?
        Is there any kind of user directions for the tool bar? The Outdoor Power Manual basically shows how to assemble the bar but not how to use it
      · 1 reply
  • Adverts

×