Jump to content

Unofficial Home of Old Simplicity & Allis-Chalmers Garden Tractors

Sign in to follow this  

mowwer will not quit turning when disengaged

Recommended Posts

BIG-10 Drive Belt# 154273 Length 42.3" Type HL Units with Low Speed Pulley use Belt# 174486 Length 48.9" Type HB Generator Belt# 1607323 Length 37.5" Type 3/8 P.T.O. Belt# 164146 Length 34.1" Type HA Power Lift Belt# 157230 Length 22" Type 3/8 Attachments 990207 32" Rotary Mower Cross Drive Belt# 108248 Length 48.1" Type HA Arbor Drive Belt# 156120 Length 63.1" Type HA Blade# 108297 Qty 3 990285 42" Rotary Mower Cross Drive Belt# 174911 Length 44.1" Type HA Arbor Drive Belt# 1719819 Length 82.1" Type HA Blade# 1656144 Qty 3 990345 36" Snowthrower Drive Belt# 106689 Length 55.5" Type HA Drive Belt# 1721533 Length 56.1" Type HA 990174 32" Tiller Drive 154273 Length 42.3" Type HL Trans. Drive Belt# 152017 Length 44.9" Type HB Drive Belt# 105122 Length 55.9" Type HB 990328 Vacuum Collector Drive Belt# 1703836 Length 91.1" Type HA 990346 46" Sickle Bar Drive Belt# 156120 Length 63.1" Type HA

Share this post

Link to post
Share on other sites
Another cause may be missing belt guide. There should be a small 'bout 1/4inch' rod towards the rear of the tractor, behind the belt and one on the bottom of the pulley to keep the belt inplace so it will be lose in the pulleies. Bet you can't mow with it disengauged...MPH

Share this post

Link to post
Share on other sites
This topic is now closed to further replies.
Sign in to follow this  

  • Who's Online (See full list)

    • CarlH
    • MARK (LI)
    • B-16_IC
    • bnolt
    • bccan
    • RenegadeJ
    • Bill725
  • Today's Birthdays

    No users celebrating today
  • Recent Status Updates

    • jbrooks

      jbrooks  »  Talntedmrgreen

      folowing  this from a link at the downloads.  I just rescued an AC 920 with the lambodini diesel. I can' t download  yet .  Where did you find the PDF copy you posted. . I would like to figure out how to adjust the injection pump. 
      I assume it's a bosche, correct
      · 0 replies
    • dav-1

      dav-1  »  Talntedmrgreen

        Over a year ago, you answered a question I had about the tool bar for my FDT. In your reply dated Dec 31, 2019  you said the spacer, part #16, goes in the bar to allow for up and down depth adjustment. does this mean the bolt has to be tightened at whatever depth desired or does the bolt slide up and down, allowing the lower hitch to free float?
         If it is tightened so the lower hitch and the bar are rigid, then is the depth to be controlled by the shoes? Or by the lift handle?
        Is there any kind of user directions for the tool bar? The Outdoor Power Manual basically shows how to assemble the bar but not how to use it
      · 1 reply
  • Adverts