Jump to content

Unofficial Home of Old Simplicity & Allis-Chalmers Garden Tractors

Sign in to follow this  
Guest

simplicity rear engine rider

Recommended Posts

Kent
These were made from 1965-1967. See the link below for more info..... Kent[A href='http://www.simpletractors.com/parts/engine/wb_&_3000_series.htm']http://www.simpletractors.com/parts/engine/wb_&_3000_series.htm[/a]

Share this post


Link to post
Share on other sites
ka9bxg
I had the same problem with my 3212. I took apart the rear end and found out that it was dry caused the rev. idler to vibrate on the shaft. A little more oil or even such a thing as fricition pruffing would help. A lot of work to take the rear end apart and parts are not cheap but still easy to get . When young our wonderboy 700 trans whent out made the god terrrible noise. That 1 costed a lot to fix a lot of the gears were worn out . It would have been a lot cheaper to keep lube in it

Share this post


Link to post
Share on other sites
Guest
This topic is now closed to further replies.
Sign in to follow this  

  • Who's Online (See full list)

    • Tom45
    • rbstuartjr
    • gwiseman
    • pgerenda
    • Bill725
    • victorsnc
    • PhanDad
  • Today's Birthdays

    1. Chad Bartlett
      Chad Bartlett
      (37 years old)
  • Recent Status Updates

    • dav-1

      dav-1  »  Talntedmrgreen

        Over a year ago, you answered a question I had about the tool bar for my FDT. In your reply dated Dec 31, 2019  you said the spacer, part #16, goes in the bar to allow for up and down depth adjustment. does this mean the bolt has to be tightened at whatever depth desired or does the bolt slide up and down, allowing the lower hitch to free float?
         If it is tightened so the lower hitch and the bar are rigid, then is the depth to be controlled by the shoes? Or by the lift handle?
        Is there any kind of user directions for the tool bar? The Outdoor Power Manual basically shows how to assemble the bar but not how to use it
      · 1 reply
    • tribswede

      tribswede  »  goatfarmer

      ISO a deck for a 6516 H and all the connecting hardware any ideas on where to start?
       
      · 1 reply
  • Adverts

×