Jump to content

Unofficial Home of Old Simplicity & Allis-Chalmers Garden Tractors

Sign in to follow this  
Scott Salmons

Hybrid Bee

Recommended Posts

Scott Salmons
I have the opportunity to buy the back half of a 3416H. Would this be good to build one of the Hybrid tractors like Kents HB-216. Pro's and Con's. Would it be better to wait for a Sundstrand? I also like the hydraulic lift.

Share this post


Link to post
Share on other sites
Kent
Scott, With an 3416H and its Vickers hydro, you could build something very close to what the HB-212 was originally. Only difference would be the cone clutch PTO, if I'm thinking correctly.

Share this post


Link to post
Share on other sites
UCD
HB-116 Built by SmilinSam Started life as a B-110 now with a Sundstrand Hydro and a 16hp briggs. I was very surprised with the work I did with it and the Johnny bucket in the woods behind my house. never got it above a fast idle all kinds of power. Sorry Sam I got it dirty moving dead trees piles of wet leaves over 1 foot deep and digging out saplings by the roots. Was having to much fun to take time to take pictures. [img]http://www.simpletractors.com/club2//attach/UCD/HB-116dirty.JPG[/img]

Share this post


Link to post
Share on other sites
Guest
This topic is now closed to further replies.
Sign in to follow this  

  • Who's Online (See full list)

    • PTurp
  • Today's Birthdays

    1. Ed Ucation
      Ed Ucation
      (70 years old)
    2. Nick Freatman
      Nick Freatman
  • Recent Status Updates

    • jbrooks

      jbrooks  »  Talntedmrgreen

      Josh
       
      folowing  this from a link at the downloads.  I just rescued an AC 920 with the lambodini diesel. I can' t download  yet .  Where did you find the PDF copy you posted. . I would like to figure out how to adjust the injection pump. 
      I assume it's a bosche, correct
      · 0 replies
    • dav-1

      dav-1  »  Talntedmrgreen

        Over a year ago, you answered a question I had about the tool bar for my FDT. In your reply dated Dec 31, 2019  you said the spacer, part #16, goes in the bar to allow for up and down depth adjustment. does this mean the bolt has to be tightened at whatever depth desired or does the bolt slide up and down, allowing the lower hitch to free float?
         If it is tightened so the lower hitch and the bar are rigid, then is the depth to be controlled by the shoes? Or by the lift handle?
        Is there any kind of user directions for the tool bar? The Outdoor Power Manual basically shows how to assemble the bar but not how to use it
      · 1 reply
  • Adverts

×