Jump to content

Unofficial Home of Old Simplicity & Allis-Chalmers Garden Tractors

Sign in to follow this  
Fred

allis B10 rear drive pulley

Recommended Posts

Fred
The pulley on the transmision of my b10 seems to slip a little under a really heavey
load, seems the set screw was slipping in what used to be the keyway, which has no key in it
with the screw going round and round ,its now cut a groove in the shaft
and the pulley does'nt want to come off, I guess I'll have to invest in a good puller,and maybe drill a hole in the shaft
to screw thatset screw into, or is it supposed to slip under heavey conditions?
Any ideas guys? Oh ya what colour is the mower deck on this model supposed to be?

Share this post


Link to post
Share on other sites
StanS
Mike, The pulley should not be slipping on the shaft. If the shaft and pulley are not damaged too much you should get a key and and fix it the right way. A puller will bend the pulley unless you use a large bearing separator behind it and pull on that. The mower deck should be yellow like the tractor.

Share this post


Link to post
Share on other sites
StanS
Hi Mike, Tim is write for sure the shaft should be fixed the write way. Contact Jeff Nemes- you can get his e-address on I think page four as he left a message on how to clean our tractors-just click on his name and his e-address will come up. He has his own shop and is always suggesting ways to not only repair our tractors but maintain them. Or you can click on back to simpletractors on the top of this page and then click on links when you get there. When you get to the links page just look for Jeff Nemes site to go to. If I recall someone else had a similer problem and he explained to them how to repair it.-->GOOD LUCK-jackl<--

Share this post


Link to post
Share on other sites
Guest
This topic is now closed to further replies.
Sign in to follow this  

  • Who's Online (See full list)

    There are no registered users currently online

  • Today's Birthdays

    No users celebrating today
  • Recent Status Updates

    • Paul M.Murphy

      Paul M.Murphy

      Hello glad I got on this site. I hope to upload a couple of photos of my Simplicity Broadmoor 
      Model 707 Tractor. I have replaced all the belts on it and installed a new ignition switch.
      Have a mower deck which was in poor shape , repaced a couple of bushings and welded the
      deck where there was some holes. The tractor and mower deck came from a friend and the 
      mower deck metal was getting pretty thin. Some new metal was put in it and we also undercoated the underside of the deck. This was done by my friend Greg Toulman.
      I have not put the mower deck on the tractor yet, waiting for Greg to come home and give me a hand. Can you please tell me if there is a manual for the mower deck and where I could get one.
      I would also like to get some moon wheel discs as well.
      I will try and down load some photos of the tractor when my wife shows me how to. 
      I really love driving this tractor and also how well it is made compare today's tractors, especially the flexible rear end and the rollers.
      Tell the next time 
      Paul
       
      · 8 replies
    • jbrooks

      jbrooks  »  Talntedmrgreen

      Josh
       
      folowing  this from a link at the downloads.  I just rescued an AC 920 with the lambodini diesel. I can' t download  yet .  Where did you find the PDF copy you posted. . I would like to figure out how to adjust the injection pump. 
      I assume it's a bosche, correct
      · 0 replies
  • Adverts

×