Jump to content

Unofficial Home of Old Simplicity & Allis-Chalmers Garden Tractors

Sign in to follow this  
oldyeller1968

Breaking a garden...

Recommended Posts

oldyeller1968
How is everyone? I have myself a standard one bottom mold board breaking plow that belonged to my grandfather, as well as his old Kubota. I finally gotten around to where I have time for a garden, but I can't for the life of me remember how to break one. We always bedded ours before-- plowing one furrow down the middle, then turning around and plowing another one so that your dirt is thrown together in the center-- and you end up with to furrows on the sides. This sounds easy enough, but for some reason, it's giving me mental fits. Any pointers?

Share this post


Link to post
Share on other sites
tractormike
You may have to adjust the depth on your plow for the first down and back run because the right wheel will not have a furrow to run in and will be higher than when plowing the rest of the field. Find the middle of the garden and set your sights on an object in the middle of the other end of the garden and drive towards it to get your first furrow straight. When you plow it next year,start in the outside furrows from this year and throw the dirt to the outside and you will have one furrow down the middle of the garden when your done. Hope this helps you.

Share this post


Link to post
Share on other sites
Kent
This supplement to the walking tractors owner's manual might be helpful. It describes laying out your garden and shows a diagram of how to plow it... http://www.simpletractors.com/Walkers/supplement.htm

Share this post


Link to post
Share on other sites
Guest
This topic is now closed to further replies.
Sign in to follow this  

  • Who's Online (See full list)

    There are no registered users currently online

  • Today's Birthdays

    No users celebrating today
  • Recent Status Updates

    • jbrooks

      jbrooks  »  Talntedmrgreen

      Josh
       
      folowing  this from a link at the downloads.  I just rescued an AC 920 with the lambodini diesel. I can' t download  yet .  Where did you find the PDF copy you posted. . I would like to figure out how to adjust the injection pump. 
      I assume it's a bosche, correct
      · 0 replies
    • dav-1

      dav-1  »  Talntedmrgreen

        Over a year ago, you answered a question I had about the tool bar for my FDT. In your reply dated Dec 31, 2019  you said the spacer, part #16, goes in the bar to allow for up and down depth adjustment. does this mean the bolt has to be tightened at whatever depth desired or does the bolt slide up and down, allowing the lower hitch to free float?
         If it is tightened so the lower hitch and the bar are rigid, then is the depth to be controlled by the shoes? Or by the lift handle?
        Is there any kind of user directions for the tool bar? The Outdoor Power Manual basically shows how to assemble the bar but not how to use it
      · 1 reply
  • Adverts

×