Jump to content

Unofficial Home of Old Simplicity & Allis-Chalmers Garden Tractors

Sign in to follow this  
Putter

Generator bearing part numbers

Recommended Posts

Putter
Does any one have handy the bearing part numbers or cross reference part numbers for rebuilding a Delco Remy starter generator? Mine has seized up and the pulley end bearing came off in pieces. No chance of getting a part number off it. It was the newer style ball bearing without the oiling hole. Any help would be appreciated. The part number of the generator is 1101980. While I am at it if someone knows the part number for brushes for the same generator they should be replaced at the same time.

Share this post


Link to post
Share on other sites
Roy
Check with member Al Eden, Sandy Lake Implements or another of our member dealers. You could also check with a local starter/generator shop and/or a bearing distributor. It is a common bearing.Can you identify it from the one on the other end? I think they are the same.

Share this post


Link to post
Share on other sites
Bunky
I don't know either I would just Try and contact a local Repair shop I took mine to a local place.. They were Great the guy put the new Bearing in and gave me brushes and it was cheap I thought.. Seems like under $10.00...

Share this post


Link to post
Share on other sites
Guest
This topic is now closed to further replies.
Sign in to follow this  

  • Who's Online (See full list)

    • CarlH
    • Homiet16
    • SmilinSam
    • reerg1
    • deebig
    • TTDE419
    • PhanDad
    • Ian C
    • a_sannine
  • Today's Birthdays

    1. Ole Settler
      Ole Settler
      (71 years old)
  • Recent Status Updates

    • jbrooks

      jbrooks  »  Talntedmrgreen

      Josh
       
      folowing  this from a link at the downloads.  I just rescued an AC 920 with the lambodini diesel. I can' t download  yet .  Where did you find the PDF copy you posted. . I would like to figure out how to adjust the injection pump. 
      I assume it's a bosche, correct
      · 0 replies
    • dav-1

      dav-1  »  Talntedmrgreen

        Over a year ago, you answered a question I had about the tool bar for my FDT. In your reply dated Dec 31, 2019  you said the spacer, part #16, goes in the bar to allow for up and down depth adjustment. does this mean the bolt has to be tightened at whatever depth desired or does the bolt slide up and down, allowing the lower hitch to free float?
         If it is tightened so the lower hitch and the bar are rigid, then is the depth to be controlled by the shoes? Or by the lift handle?
        Is there any kind of user directions for the tool bar? The Outdoor Power Manual basically shows how to assemble the bar but not how to use it
      · 1 reply
  • Adverts

×