Jump to content

Unofficial Home of Old Simplicity & Allis-Chalmers Garden Tractors

Sign in to follow this  
rbegley001

'64 Landlord runs again after 16 years

Recommended Posts

rbegley001
:DDe-lurking for a while to let you all know My Grandfather purchased a 1964 landlord after his first heart attack, we ran it to mow lawns, roto-til, and haul things until 1987 or so, the tiller got replaced by a walk behind and so did the mower, well for the first time in 16 years, with some TLC and a cleaned up carb, I drove it around my yard with a big smile on my face. It does need an air filter and Muffler, but other than that runs like it did when we put it away . Next project will be to get the Muffer replaced(currently only had the pipe sticking out). I have to say without this site and forums I wouldn't have been able to do it, this is just such a wealth of info. Thanks Richard '64 Landlord (work in progress)

Share this post


Link to post
Share on other sites
Tom_Byrne
Good for you! Welcome to the club. I just re-did a 2010, same as my Grandfather had. Brought back a lot of old memories for the whole family. :D You are lucky to have his original iron- wish I had my Grandfathers. Restore it, cherish it, and keep us posted!:D

Share this post


Link to post
Share on other sites
Guest
This topic is now closed to further replies.
Sign in to follow this  

  • Who's Online (See full list)

    • airgunner
    • Colib17
    • PTurp
    • Mine19821
    • casinojim
    • Bear
    • TomSchmit
    • Bill725
    • CarlH
  • Today's Birthdays

    No users celebrating today
  • Recent Status Updates

    • jbrooks

      jbrooks  »  Talntedmrgreen

      Josh
       
      folowing  this from a link at the downloads.  I just rescued an AC 920 with the lambodini diesel. I can' t download  yet .  Where did you find the PDF copy you posted. . I would like to figure out how to adjust the injection pump. 
      I assume it's a bosche, correct
      · 0 replies
    • dav-1

      dav-1  »  Talntedmrgreen

        Over a year ago, you answered a question I had about the tool bar for my FDT. In your reply dated Dec 31, 2019  you said the spacer, part #16, goes in the bar to allow for up and down depth adjustment. does this mean the bolt has to be tightened at whatever depth desired or does the bolt slide up and down, allowing the lower hitch to free float?
         If it is tightened so the lower hitch and the bar are rigid, then is the depth to be controlled by the shoes? Or by the lift handle?
        Is there any kind of user directions for the tool bar? The Outdoor Power Manual basically shows how to assemble the bar but not how to use it
      · 1 reply
  • Adverts

×