Jump to content

Unofficial Home of Old Simplicity & Allis-Chalmers Garden Tractors

Sign in to follow this  

B212 engine specs

Recommended Posts

I must replace the engine in my AC B212 and do not have the orginal. Local small engine dealers are not helpful (even the Simplicity dealer). Can anyone give me an engine model number that can be used without modification? Bill

Share this post

Link to post
Share on other sites
I've got a Tecumseh OH160 in my 210. It does require some modification to the tractor. Engine must be raised about 3/4 inch and mounting is made to the side of the engine, not the bottom. Steve

Share this post

Link to post
Share on other sites
I don't know how much different the 212 is from the 112, but my B-112 has the Briggs Model 300421, Type 012701 in it. Don Newberry has a 12 hp Briggs that needs a rebuild in the classifieds. Here's the link.... http://www.simpletractors.com/club2/classDetail.asp?id=3200

Share this post

Link to post
Share on other sites
This topic is now closed to further replies.
Sign in to follow this  

  • Who's Online (See full list)

    • RickS
    • Bird76Mojo
    • Ezra Burgess
    • bccan
    • NateShedivy
    • MARK (LI)
  • Today's Birthdays

    No users celebrating today
  • Recent Status Updates

    • jbrooks

      jbrooks  »  Talntedmrgreen

      folowing  this from a link at the downloads.  I just rescued an AC 920 with the lambodini diesel. I can' t download  yet .  Where did you find the PDF copy you posted. . I would like to figure out how to adjust the injection pump. 
      I assume it's a bosche, correct
      · 0 replies
    • dav-1

      dav-1  »  Talntedmrgreen

        Over a year ago, you answered a question I had about the tool bar for my FDT. In your reply dated Dec 31, 2019  you said the spacer, part #16, goes in the bar to allow for up and down depth adjustment. does this mean the bolt has to be tightened at whatever depth desired or does the bolt slide up and down, allowing the lower hitch to free float?
         If it is tightened so the lower hitch and the bar are rigid, then is the depth to be controlled by the shoes? Or by the lift handle?
        Is there any kind of user directions for the tool bar? The Outdoor Power Manual basically shows how to assemble the bar but not how to use it
      · 1 reply
  • Adverts