Jump to content

Unofficial Home of Old Simplicity & Allis-Chalmers Garden Tractors

Sign in to follow this  
plowman

need exploded view

Recommended Posts

plowman
I've got a hydro pump/hyd. motor part #166097 it's in a T-16,but the simplicity manual I downloaded from the tech dept. shows same part #. Mine is leaking from the front shaft where the control link goes on (the part that shifts forward , reverse) There has to be an o-ring or a seal in there.But I can't find an exploded view of it anywhere, I'd like to have an exploded view before I tear it apart, It's a strong unit so I really don't want to send off to have it rebuild,& I've heard the new ones are around $800-$1,000!!!! Thanks, Plowman

Share this post


Link to post
Share on other sites
Brent_Baumer
If it is a Vickers, which sounds likely as most leaked around the pintle shaft, forget getting a new one. There was a place in Illinois the rebuilt the pumps on these units for $100 plus shipping. I think it was called Central Hydraulics. Don't remember the city right now. Search for Vickers on this site, including the archives and you'll find pages of info on this topic. Brent

Share this post


Link to post
Share on other sites
Guest
This topic is now closed to further replies.
Sign in to follow this  

  • Who's Online (See full list)

    • tripleguy
    • Stanleylourb
    • MARK (LI)
  • Today's Birthdays

    1. Chris727
      Chris727
      (36 years old)
    2. jdwilson
      jdwilson
      (64 years old)
  • Recent Status Updates

    • jbrooks

      jbrooks  »  Talntedmrgreen

      Josh
       
      folowing  this from a link at the downloads.  I just rescued an AC 920 with the lambodini diesel. I can' t download  yet .  Where did you find the PDF copy you posted. . I would like to figure out how to adjust the injection pump. 
      I assume it's a bosche, correct
      · 0 replies
    • dav-1

      dav-1  »  Talntedmrgreen

        Over a year ago, you answered a question I had about the tool bar for my FDT. In your reply dated Dec 31, 2019  you said the spacer, part #16, goes in the bar to allow for up and down depth adjustment. does this mean the bolt has to be tightened at whatever depth desired or does the bolt slide up and down, allowing the lower hitch to free float?
         If it is tightened so the lower hitch and the bar are rigid, then is the depth to be controlled by the shoes? Or by the lift handle?
        Is there any kind of user directions for the tool bar? The Outdoor Power Manual basically shows how to assemble the bar but not how to use it
      · 1 reply
  • Adverts

×