Jump to content

Unofficial Home of Old Simplicity & Allis-Chalmers Garden Tractors

Sign in to follow this  
grayford

New here

Recommended Posts

grayford
Ok i have a old b-110 that i bought for 50.00. with snow blower and mower However the mower needs new blade pully etc. where can i locate these, or should i just rebuild the tractoe and keep it as a snowblower. and help will be much appreciated. The tractor runs but i think its due a new carb. and was garage kept. also have a leaf vac. to

Share this post


Link to post
Share on other sites
kdhehr
Hi, and welcome to the club. Try going to the classified section and go from there. From day to day things change and you just might find what you are looking for. Sorry I cant help more than that. Again welcome! Kenny

Share this post


Link to post
Share on other sites
IronPony
Welcome to the club/forum, Darryl. Someone on here will have a part number for you if you can provide enough info to ID the tractor/deck. Have fun with a great tractor that BTW you stole for $50.:D Dan

Share this post


Link to post
Share on other sites
thedaddycat
Welcome to the club and congratulations on a great find and a fantastic deal. You can rebuild the carb, A Briggs factory kit is under $25, aftermarket kit even less. You might find those mower parts are still available from the dealer.

Share this post


Link to post
Share on other sites
Guest
This topic is now closed to further replies.
Sign in to follow this  

  • Who's Online (See full list)

    • PhanDad
    • plastikosmd
    • Ronald Hribar
    • ac.d17iv
  • Today's Birthdays

    1. Ole Settler
      Ole Settler
      (71 years old)
  • Recent Status Updates

    • jbrooks

      jbrooks  »  Talntedmrgreen

      Josh
       
      folowing  this from a link at the downloads.  I just rescued an AC 920 with the lambodini diesel. I can' t download  yet .  Where did you find the PDF copy you posted. . I would like to figure out how to adjust the injection pump. 
      I assume it's a bosche, correct
      · 0 replies
    • dav-1

      dav-1  »  Talntedmrgreen

        Over a year ago, you answered a question I had about the tool bar for my FDT. In your reply dated Dec 31, 2019  you said the spacer, part #16, goes in the bar to allow for up and down depth adjustment. does this mean the bolt has to be tightened at whatever depth desired or does the bolt slide up and down, allowing the lower hitch to free float?
         If it is tightened so the lower hitch and the bar are rigid, then is the depth to be controlled by the shoes? Or by the lift handle?
        Is there any kind of user directions for the tool bar? The Outdoor Power Manual basically shows how to assemble the bar but not how to use it
      · 1 reply
  • Adverts

×