Jump to content

Unofficial Home of Old Simplicity & Allis-Chalmers Garden Tractors


Weet Cutter ID.NO. ???

Recommended Posts

Drigon,If you are talking about the 40inch rough cut mower that mounts to the front of the tractor.I belive that the mower itself is all the same MFG 990370.You just need a hitch to hook it to your tractor (I think).There was a post a while back about hooking them to the Broadmoor which is about the same as the Yeoman..Somewhere in the contents section of simple tractors there is a flyer/ad that shows a picture of a Broadmoor with the cutter on it...I can't seem to find it now..

Share this post

Link to post
Share on other sites
This topic is now closed to further replies.

  • Who's Online (See full list)

    • Horvik
    • simplewrench
    • Chris89
    • MARK (LI)
    • RenegadeJ
    • Freetractor
    • RAC
    • SmilinSam
  • Today's Birthdays

    1. dbulkley62
      (59 years old)
  • Recent Status Updates

    • jbrooks

      jbrooks  »  Talntedmrgreen

      folowing  this from a link at the downloads.  I just rescued an AC 920 with the lambodini diesel. I can' t download  yet .  Where did you find the PDF copy you posted. . I would like to figure out how to adjust the injection pump. 
      I assume it's a bosche, correct
      · 0 replies
    • dav-1

      dav-1  »  Talntedmrgreen

        Over a year ago, you answered a question I had about the tool bar for my FDT. In your reply dated Dec 31, 2019  you said the spacer, part #16, goes in the bar to allow for up and down depth adjustment. does this mean the bolt has to be tightened at whatever depth desired or does the bolt slide up and down, allowing the lower hitch to free float?
         If it is tightened so the lower hitch and the bar are rigid, then is the depth to be controlled by the shoes? Or by the lift handle?
        Is there any kind of user directions for the tool bar? The Outdoor Power Manual basically shows how to assemble the bar but not how to use it
      · 1 reply
  • Adverts