Jump to content

Unofficial Home of Old Simplicity & Allis-Chalmers Garden Tractors

Sign in to follow this  
IronPony

Fixed Jet Carb on K341

Recommended Posts

IronPony
I find that this K341 engine was used on a generator/starting unit and ran at a constant speed. The engine has a Fixed Jet carb. Are there any problems associated with using the fixed jet carb on my tractor?? Thanks, Dan PS - I am also in the market for a good head for this engine.

Share this post


Link to post
Share on other sites
HubbardRA
A fixed jet carb is fine as long as it has the correct jet in it. I had a Vanguard that ran too lean and required half choke to mow. I took a small drill and opened the jet by .001 inch to make it run correctly. Just don't do any drilling on a jet if you don't know exactly how to do it or how much you need. I don't think the jets are sold separately.

Share this post


Link to post
Share on other sites
Guest
This topic is now closed to further replies.
Sign in to follow this  

  • Who's Online (See full list)

    • MRR
    • simplewrench
    • s_stephen
    • Chris727
    • hotrodtractor
    • phillobbezoo
  • Today's Birthdays

    1. Ed Ucation
      Ed Ucation
      (70 years old)
    2. Nick Freatman
      Nick Freatman
  • Recent Status Updates

    • jbrooks

      jbrooks  »  Talntedmrgreen

      Josh
       
      folowing  this from a link at the downloads.  I just rescued an AC 920 with the lambodini diesel. I can' t download  yet .  Where did you find the PDF copy you posted. . I would like to figure out how to adjust the injection pump. 
      I assume it's a bosche, correct
      · 0 replies
    • dav-1

      dav-1  »  Talntedmrgreen

        Over a year ago, you answered a question I had about the tool bar for my FDT. In your reply dated Dec 31, 2019  you said the spacer, part #16, goes in the bar to allow for up and down depth adjustment. does this mean the bolt has to be tightened at whatever depth desired or does the bolt slide up and down, allowing the lower hitch to free float?
         If it is tightened so the lower hitch and the bar are rigid, then is the depth to be controlled by the shoes? Or by the lift handle?
        Is there any kind of user directions for the tool bar? The Outdoor Power Manual basically shows how to assemble the bar but not how to use it
      · 1 reply
  • Adverts

×