Jump to content

Unofficial Home of Old Simplicity & Allis-Chalmers Garden Tractors

Sign in to follow this  
JeffN

Grinding

Recommended Posts

JeffN
My 728 Broadmoor has been grinding when shifting the tranny into any gear 1,2,3 and even reverse. I have tried adjusting the set collar according the the manual but it still grinds. Anything else that I can check/adjust. Thanks.

Share this post


Link to post
Share on other sites
rokon2813
Are all your belt guides in place they should each be about 1/8" from the belt. Beleive it or not those little wire guides too play an important part in stopping the belt. Be aware very few belts stop instantly so all older tractors grind a little if you try to shift in a hurry. After you check all the guides and make sure all the linkages move freely, when you try to shift, wait a split second after you put in the clutch before you try to change gears. See if this helps.

Share this post


Link to post
Share on other sites
Guest
This topic is now closed to further replies.
Sign in to follow this  

  • Who's Online (See full list)

    • JClubine
    • rokon2813
    • Ronald Hribar
    • PhanDad
  • Today's Birthdays

    1. 9934059
      9934059
      (71 years old)
  • Recent Status Updates

    • jbrooks

      jbrooks  »  Talntedmrgreen

      Josh
       
      folowing  this from a link at the downloads.  I just rescued an AC 920 with the lambodini diesel. I can' t download  yet .  Where did you find the PDF copy you posted. . I would like to figure out how to adjust the injection pump. 
      I assume it's a bosche, correct
      · 0 replies
    • dav-1

      dav-1  »  Talntedmrgreen

        Over a year ago, you answered a question I had about the tool bar for my FDT. In your reply dated Dec 31, 2019  you said the spacer, part #16, goes in the bar to allow for up and down depth adjustment. does this mean the bolt has to be tightened at whatever depth desired or does the bolt slide up and down, allowing the lower hitch to free float?
         If it is tightened so the lower hitch and the bar are rigid, then is the depth to be controlled by the shoes? Or by the lift handle?
        Is there any kind of user directions for the tool bar? The Outdoor Power Manual basically shows how to assemble the bar but not how to use it
      · 1 reply
  • Adverts

×