Jump to content

Unofficial Home of Old Simplicity & Allis-Chalmers Garden Tractors

Sign in to follow this  
IronPony

Need Head for K341

Recommended Posts

IronPony
My K341 has a bad spark plug hole with stripped threads. I was going to heli-coil but found that had already been done once:( so I don't want to do it again. Anyone have a good head for this K341 engine? Please PM, post here or email me maplwood@eot.com Thanks, Dan

Share this post


Link to post
Share on other sites
jlasater
Even if the heli-coil pulled out, you should still be able to get a threaded insert installed. The insert in question is basically a tube that's threaded on both sides, one for the sparkplug, outside to fit in the head.

Share this post


Link to post
Share on other sites
IronPony
At the advice of those that responded to this post, I took the head in to my local machine shop and they are going to repair it. Thanks to both of you for offering your experience and wisdom. Dan

Share this post


Link to post
Share on other sites
Guest
This topic is now closed to further replies.
Sign in to follow this  

  • Who's Online (See full list)

    • BruceH
    • CarlH
    • plastikosmd
    • tadams
  • Today's Birthdays

    1. Ole Settler
      Ole Settler
      (71 years old)
  • Recent Status Updates

    • jbrooks

      jbrooks  »  Talntedmrgreen

      Josh
       
      folowing  this from a link at the downloads.  I just rescued an AC 920 with the lambodini diesel. I can' t download  yet .  Where did you find the PDF copy you posted. . I would like to figure out how to adjust the injection pump. 
      I assume it's a bosche, correct
      · 0 replies
    • dav-1

      dav-1  »  Talntedmrgreen

        Over a year ago, you answered a question I had about the tool bar for my FDT. In your reply dated Dec 31, 2019  you said the spacer, part #16, goes in the bar to allow for up and down depth adjustment. does this mean the bolt has to be tightened at whatever depth desired or does the bolt slide up and down, allowing the lower hitch to free float?
         If it is tightened so the lower hitch and the bar are rigid, then is the depth to be controlled by the shoes? Or by the lift handle?
        Is there any kind of user directions for the tool bar? The Outdoor Power Manual basically shows how to assemble the bar but not how to use it
      · 1 reply
  • Adverts

×