Jump to content

Unofficial Home of Old Simplicity & Allis-Chalmers Garden Tractors

DaleC

Axles seem to be moving in and out.

Recommended Posts

DaleC
I clean up my B-12 tranny on a pretty regular basis. All the oil that spills out of the shifter in the back of the tractor catches a lot of grass and dirt as I am sure all Bee owners are aware:). I have been noticing that where the axles come out of the rear end that it shows up shiney like the axles are moving in and out of the case. It is almost 3/8 wide. Is this normal? Do I need to do some preventative maintanence? Thanks guys, in advance. Hope you put my mind at ease.xx(

Share this post


Link to post
Share on other sites
Chris727
My B-110 and 3410 Landlord leak from the shifter, I think there is an O-ring or some kind of oil seal that must have gone bad, I plan to tear down my B-110's transmssion and put all new seals in it. Sorry but I don't know about the axel. -Chris

Share this post


Link to post
Share on other sites
Guest
This topic is now closed to further replies.

  • Who's Online (See full list)

    • newellhvac
    • MARK (LI)
    • SmilinSam
    • GregB
    • MRR
    • PhanDad
    • simplewrench
    • airgunner
    • CarlH
  • Today's Birthdays

    No users celebrating today
  • Recent Status Updates

    • jbrooks

      jbrooks  »  Talntedmrgreen

      Josh
       
      folowing  this from a link at the downloads.  I just rescued an AC 920 with the lambodini diesel. I can' t download  yet .  Where did you find the PDF copy you posted. . I would like to figure out how to adjust the injection pump. 
      I assume it's a bosche, correct
      · 0 replies
    • dav-1

      dav-1  »  Talntedmrgreen

        Over a year ago, you answered a question I had about the tool bar for my FDT. In your reply dated Dec 31, 2019  you said the spacer, part #16, goes in the bar to allow for up and down depth adjustment. does this mean the bolt has to be tightened at whatever depth desired or does the bolt slide up and down, allowing the lower hitch to free float?
         If it is tightened so the lower hitch and the bar are rigid, then is the depth to be controlled by the shoes? Or by the lift handle?
        Is there any kind of user directions for the tool bar? The Outdoor Power Manual basically shows how to assemble the bar but not how to use it
      · 1 reply
  • Adverts

×