Jump to content

Unofficial Home of Old Simplicity & Allis-Chalmers Garden Tractors

Sign in to follow this  
ChrisACB-112

3310/3410 hydro in a B-112

Recommended Posts

ChrisACB-112
I have a B-112 with the varidrive and repowered with a 16hp. I want the hydro because the tractor is mostly used by my kids to mow lawns and I like the added control of the hydro. I have a line on a hydro from a 3310 or 3410 and it looks like it will go smoothly, but I can only tell so much from pictures. Does anyone know about this swap? Will the additional horsepower be too much for a hydro that was originally mated to a 10hp?

Share this post


Link to post
Share on other sites
UCD
No problem Kent and sam have both done it with a sunstrand hydro unit The hydro in the 3310 and 3410 series are a vickers hydro but the conversion should be close to the same. I now have the HB-116 that Sam built. It is one very nice running tractor. Link to Kents conversion [url]http://www.simpletractors.com/do_it/variable_to_hydro.htm[/url] Link to Sam's Conversion [url]http://www.simpletractors.com/do_it/variable_to_hydro2.htm[/url]

Share this post


Link to post
Share on other sites
Guest
This topic is now closed to further replies.
Sign in to follow this  

  • Who's Online (See full list)

    • OntBoy
    • CarlH
    • Jful1
    • plastikosmd
    • Ian C
    • Bill725
  • Today's Birthdays

    1. Ole Settler
      Ole Settler
      (71 years old)
  • Recent Status Updates

    • jbrooks

      jbrooks  »  Talntedmrgreen

      Josh
       
      folowing  this from a link at the downloads.  I just rescued an AC 920 with the lambodini diesel. I can' t download  yet .  Where did you find the PDF copy you posted. . I would like to figure out how to adjust the injection pump. 
      I assume it's a bosche, correct
      · 0 replies
    • dav-1

      dav-1  »  Talntedmrgreen

        Over a year ago, you answered a question I had about the tool bar for my FDT. In your reply dated Dec 31, 2019  you said the spacer, part #16, goes in the bar to allow for up and down depth adjustment. does this mean the bolt has to be tightened at whatever depth desired or does the bolt slide up and down, allowing the lower hitch to free float?
         If it is tightened so the lower hitch and the bar are rigid, then is the depth to be controlled by the shoes? Or by the lift handle?
        Is there any kind of user directions for the tool bar? The Outdoor Power Manual basically shows how to assemble the bar but not how to use it
      · 1 reply
  • Adverts

×