Jump to content

Unofficial Home of Old Simplicity & Allis-Chalmers Garden Tractors

Sign in to follow this  
TOMT

STARTING PROBLEM

Recommended Posts

TOMT
I HAVE A PROBLEM ON A 3210V WITH THE STARTER-GENERATOR. IT GENERALLY STARTS (VERY SLOW) OK BUT OCCASIONALLY(LIKE NOW)I ONLY GET A TIC-TIC SOUND(LIKE A STUCK SOLENOID)& THE STARTER-GENERATOR WILL NOT ROTATE.I HAVE TRIED USING JUMPER CABLES ITH NO SUCCESS. I'M NOT REAL FAMILIAR WITH THE ELECTRONICS OF THIS ARRANGEMENT. I WOULD APPRECIATE ANY GUIDANCE OR SUGGESTIONS AS TO HOW TO SOLVE THIS SITUATION. WHAT DOES A NEW OR REBUILT STARTER-GENERATOR COST?? IF NEEDED DOES ANYONE HAVE ONE FOR SALE?? THKS,TOM

Share this post


Link to post
Share on other sites
Kent
Tom, Your problem doesn,t sound like the starter/generator is bad, it sounds more like wiring, selenoid, or battery. Is the battery being charged? What is the general condition of the wiring and the battery clamps? The 3210 also has a safety switch under the seat pan that keeps the starter from working when the tractor is in gear, I had that go bad on a 3212. I think it would be much less costly to have your starter/generator rebuilt at a shop than to buy a new one if it is in fact bad. Tim

Share this post


Link to post
Share on other sites
Guest
This topic is now closed to further replies.
Sign in to follow this  

  • Who's Online (See full list)

    • Bob75
    • gwiseman
    • Ronald Hribar
    • Tom45
    • rbstuartjr
    • pgerenda
  • Today's Birthdays

    1. Chad Bartlett
      Chad Bartlett
      (37 years old)
  • Recent Status Updates

    • dav-1

      dav-1  »  Talntedmrgreen

        Over a year ago, you answered a question I had about the tool bar for my FDT. In your reply dated Dec 31, 2019  you said the spacer, part #16, goes in the bar to allow for up and down depth adjustment. does this mean the bolt has to be tightened at whatever depth desired or does the bolt slide up and down, allowing the lower hitch to free float?
         If it is tightened so the lower hitch and the bar are rigid, then is the depth to be controlled by the shoes? Or by the lift handle?
        Is there any kind of user directions for the tool bar? The Outdoor Power Manual basically shows how to assemble the bar but not how to use it
      · 1 reply
    • tribswede

      tribswede  »  goatfarmer

      ISO a deck for a 6516 H and all the connecting hardware any ideas on where to start?
       
      · 1 reply
  • Adverts

×