Jump to content

Unofficial Home of Old Simplicity & Allis-Chalmers Garden Tractors

Sign in to follow this  
tej

breakerless ignition box

Recommended Posts

tej
The breakerless ignition box has been mentioned many times on this forum. My question is where does it pick up it's timing. Is there a sensor that mounts in the breaker housing? Do you still use the magnito or do you go to a coil? Tim

Share this post


Link to post
Share on other sites
dlcentral
You continue to use your existing coil.Instead of the points turning the coil on and off this little box does it electronically.Timing is built into the electronics of the box.It has to have a good ground to function properly,is the only requirement.You simply re-rout the wires going into the points box to this thing,ground it good and that's it!Prices apparently run form 12 to 20 bucks depending where you get it.Points of today as we ALL know are NOT the quality they once were. CHINA MADE probably even the OEM Briggs ones. Just like everything else made today! dlc

Share this post


Link to post
Share on other sites
Guest
This topic is now closed to further replies.
Sign in to follow this  

  • Who's Online (See full list)

    • Jac
  • Today's Birthdays

    1. Jcarlton300@gmail.com
      Jcarlton300@gmail.com
      (30 years old)
  • Recent Status Updates

    • dav-1

      dav-1  »  Talntedmrgreen

        Over a year ago, you answered a question I had about the tool bar for my FDT. In your reply dated Dec 31, 2019  you said the spacer, part #16, goes in the bar to allow for up and down depth adjustment. does this mean the bolt has to be tightened at whatever depth desired or does the bolt slide up and down, allowing the lower hitch to free float?
         If it is tightened so the lower hitch and the bar are rigid, then is the depth to be controlled by the shoes? Or by the lift handle?
        Is there any kind of user directions for the tool bar? The Outdoor Power Manual basically shows how to assemble the bar but not how to use it
      · 1 reply
    • tribswede

      tribswede  »  goatfarmer

      ISO a deck for a 6516 H and all the connecting hardware any ideas on where to start?
       
      · 1 reply
  • Adverts

×