Jump to content

Unofficial Home of Old Simplicity & Allis-Chalmers Garden Tractors

Sign in to follow this  
Guest

Landlord 64/65;engineB&S 23D model

Recommended Posts

Guest
Hi everyone.I`m from ROMANIA and I have a Landlord 314 since 64/65 with B&S engine 23D model,0129-02 type,42063 serie.I have problems with the engine.I need a repair manual for it or a suggestion for change it.Can I change it with a B&S engine model 326431 (16 HP )? The 23D has just 9HP. For 23D I need a carburetor and I didn`t find it here in ROMANIA.For make the change with 326431 model I need information about the engine (technical specifications),can you help me? Let`s say "Simplicity the Best!" Dan

Share this post


Link to post
Share on other sites
Kent
Dan, Welcome to the group. I'll jump in, and hope others will correct me if I'm wrong. I think the 326431 will bolt right in, if you can find one. As far as I know it was used interchangeably with the 243431 10HP and 300421 12HP in the same tractors. And, the 243431 replaced the 23D model you have.... They weren't available in AC's (that I know of) since AC was building their tractors in Lexington (400 Series with Kohlers) while Simplicity was building their own with Briggs by the time the HP was raised to 16.... I don't think AC ever used the 16HP single Briggs, but I may be wrong.... I don't have any specs on the engine, here's a link to the 73 Sovereign that used it... [A href='http://www.simpletractors.com/simplicity/new_in_1973/sovereign_specs.htm']http://www.simpletractors.com/simplicity/new_in_1973/sovereign_specs.htm[/a]

Share this post


Link to post
Share on other sites
Guest
Thank`s Kent.I found a 326431 at B&S dealer from Switzerland but it cost 1,130.80$ without shipping and it`s to much for me.I think I will make an electronic ignition for the engine and change the carburetor with one from a romanian engine.It may be work!I will tell you what it`s the result.Thank`s again! Dan

Share this post


Link to post
Share on other sites
Guest
This topic is now closed to further replies.
Sign in to follow this  

  • Who's Online (See full list)

    • MARK (LI)
    • rich_kildow
    • MrSteele
    • bowhunt4life
  • Today's Birthdays

    1. Chad Bartlett
      Chad Bartlett
      (37 years old)
  • Recent Status Updates

    • dav-1

      dav-1  »  Talntedmrgreen

        Over a year ago, you answered a question I had about the tool bar for my FDT. In your reply dated Dec 31, 2019  you said the spacer, part #16, goes in the bar to allow for up and down depth adjustment. does this mean the bolt has to be tightened at whatever depth desired or does the bolt slide up and down, allowing the lower hitch to free float?
         If it is tightened so the lower hitch and the bar are rigid, then is the depth to be controlled by the shoes? Or by the lift handle?
        Is there any kind of user directions for the tool bar? The Outdoor Power Manual basically shows how to assemble the bar but not how to use it
      · 1 reply
    • tribswede

      tribswede  »  goatfarmer

      ISO a deck for a 6516 H and all the connecting hardware any ideas on where to start?
       
      · 1 reply
  • Adverts

×