carry/weight box

[ehertzfeld]

I just made a steel box for weight and for stuff. I now have to figure out how to mount it to the rear of my landloard. Any onr have any suggestions? Pictures would be the most helpfull. How much can the rear lift.... well lift? could I use that and how? I do have some Ideas but I would like to get others imput. Thanks ELon

[thedaddycat]

Elon, you just need to make another trip down here during daylight... I have both a Johnny Box and a Carry-All Box you can look at, measure, or do just about anything else you want with.

[gregc]

Take a look at this, Elon: http://www.simplicitytechpubs.com/6767PRINT/PDF_files/TP_400_1248_00_AT_S.pdf

[Kent]

Here's you some more ideas, also: http://www.simpletractors.com/operation/johnny_box.htm

[ehertzfeld]

here are some pics of the box. I tryed to use a tape mesure but it didnt come out like id hope. but its 19.5 long by 8.5 wide and 8 high.

I am planning on using it for weight for plowing as well as a place to put a gas can. I hate to be at the bottom of my 700ft drive way and run out of gas lol. I want to be able to remove it easily as well. I also need to come up with one for my Broadmoor for a gas can. Elon

[RickS]

Elon, Quote: "I am planning on using it for weight for plowing as well as a place to put a gas can. I hate to be at the bottom of my 700ft drive way and run out of gas lol" Been there done that only I was at the end of my 1,200 foot driveway and the gas tank in the garage was full. Rick.........

[ehertzfeld]

Well I think I figured it out. I used the same idea as the Jhonny Box. just going to reinforc the bottom arms, then paint!

[gregc]

Good job, Elon.8D Nice counter weight for the plow, weight can be easily adjusted.