a7117puller Posted November 17, 2003 Posted November 17, 2003 3314v project that im working on now, well, long story short, looked like the tractor rolled at one point in time. so the hood is lil off to one side and dented. tractor had a snowblower attachment on the front when i got it, and someone welded some scrap pieces of steel to the frame and gave the hood a lil lift on the front for a gap for one of the rod linkages for the snowblower to go through, well, the bottom was cut and bent to let the linkage for the snowblower move. and now i ripped the shroud/shield for the muffler out from it, so i could pound the dents on the front top out. so just need to weld and grind the cracks and holes on that darn hood now. Got most of it done and painted, cept for part of the dash, hood, seat deck, running boards, wheels. wish i could have cromed the whole frame, but didnt know how much that would have been. rattle can paint job, but not the best job in the world. got the rear and engine to paint in the spring. took a 16hp b/s cast iron engine from donor tractor, found out its .020 over or so:D and am goin to try to tinker with a fuel mix later too}:). i have yet to talk to a buddy to see if he can make some decals for it too. ill post a few pics when i get a lil more done with it.
Recommended Posts