Jump to content

Unofficial Home of Old Simplicity & Allis-Chalmers Garden Tractors

Sign in to follow this  
oldone

Wheel weights

Recommended Posts

oldone
I had some time at work to make these Aluminum wheel weights at work. They were made to fit inside of the wheels. all the work was done on a CNC mill that I run there. 3.125 wide 10.125 od 6" bore with a 25deg. taper wt# 39lbs.

Share this post


Link to post
Share on other sites
mowerman1193
Is that center hole big enough to be able to get to the lug bolts without removing the weight??I always thought they should have a way to remove the wheel without removing the weight... Very nice job...

Share this post


Link to post
Share on other sites
dirtsaver
Wow John those are class! I'd never thought of something that nice for weights! Kevin I'm just guessing but the hole looks big enough to acess the lug bolts. For sure they look bigger than the center holes in the factory weights that came with my Simp 3012V. Larry

Share this post


Link to post
Share on other sites
oldone
I hope that they will fit over the hub ok, if not I will have to recut them. they are a nice fit in the wheel! the one is side flat so I could add more weights if need be. By the way there are not Aluminum, but 401 stainless steel. started out with left over stock that was laying around, it just took a little while to get some the size that I needed. it was 11"x 5" by 3.25 long tubing when I started them. then to find the time to get them cut. But they are done for now! (I hope) John

Share this post


Link to post
Share on other sites
Guest
This topic is now closed to further replies.
Sign in to follow this  

×