Jump to content

Unofficial Home of Old Simplicity & Allis-Chalmers Garden Tractors

400 series bevel gear box into a 700 series?


jackcobb

Recommended Posts

From the looks of mine (as best as I can see) they look the same. It looks to be the same as the ones on my 712S and 716H. You may need to change the tranny drive pulley if they are not the same tranny.
Link to comment
Share on other sites

Shouldn't be a problem or any modifications needed as long as the shaft is long enough to fit your cone clutch PTO onto the 410 BGB.
Link to comment
Share on other sites

maxtorman1234
It will work, I would just change the shaft if it is ok, because I dont think the clutch from the 700 will work on the 400 shaft. Also one other really frustrating thing, is that the 400 series bgb wont have the dipstick to check/add oil to it. I wish I switched one of mine when I had the chance! Also will probably have to change the drive pully as HubbardRA said, because the diameter might be different and maybe the spacers too.
Link to comment
Share on other sites

Guest
This topic is now closed to further replies.
×
×
  • Create New...