Jump to content

Unofficial Home of Old Simplicity & Allis-Chalmers Garden Tractors

seat


ehertzfeld

Recommended Posts

I was wondering if some one could do me a favor. I want to make a couple of seats. One for my 64 landlord and one for my 65 broadmoor. I need to know the measurments of the plywood. Also, should I use 2inch or 1 1/2 inch flat stock. Thanks Elon
Link to comment
Share on other sites

Elon, I just went and tried to get the measurements off my B-210. The armrests are gone and as near as I can tell, back is 6" X 13 1/2", and seat bottom is 16 1/2" X 12". Hope this helps.
Link to comment
Share on other sites

I know this is not even close to the original, but i like it and it sits great. I used 2" x 1/4 flat steel, 3/4 plywood, the bottom has 1 1/2" of high density foam(carpet padding), the arm rest will hold my body weight and move up and out of the way. Also the seat is adjustable some 4" front to back. My cost is around $15.

Link to comment
Share on other sites

Guest
This topic is now closed to further replies.
×
×
  • Create New...