Jump to content

Unofficial Home of Old Simplicity & Allis-Chalmers Garden Tractors

Pivot bearing


oldone

Recommended Posts

I bought this 2 speed pulley that had this for a pivot bearing. looks to be a good replacement for the original one. now to get another one made like it.

Better picture I hope
Link to comment
Share on other sites

John, Not really ignoring your post, but I don't have a two speed so I don't know the part. Thought you would get comments from others familiar with the part. Guess not up till now. From the new picture, it looks like a piece of rod, a couple of pieces of flat bar, and a welder is all that is needed to reproduce the part.
Link to comment
Share on other sites

doesn't look like anything I have ever seen on my two speed pulley's on my b-10 and sim. 101. But it looks like it should work. If you give me the dimentions I could make you one.
Link to comment
Share on other sites

Started making new pivot bearings. Cutting the shank to .44 by .75 long.

Cutting top to .65 long with .375 wide slot .5 deep.

now there ready for some inlay ( have to see want I can get done at work)

Link to comment
Share on other sites

Nice work! But these parts are still avaible from a dealer. the pivot # is 157353- 20.65 and the insert is 157354-8.15 this is what the prices were about 6 months ago. and they had 4 in stock.
Link to comment
Share on other sites

Guest
This topic is now closed to further replies.
×
×
  • Create New...