Jump to content

Unofficial Home of Old Simplicity & Allis-Chalmers Garden Tractors

Bent Hydro Lift Lever ???


stevenj

Recommended Posts

Take a look at this picture and let me know if my hydro lift lever is actually bent or if this is how they are supposed to be. I clamped a straight edge to the lower edge of the lift lever to show the relationship to the handle. If you could do the same on yours and let me know what it looks like I'd appreciate it. Thanks. As you can see, I'm not quite ready for winter.

Link to comment
Share on other sites

Just out of curiosity is that a vertical shaft engine in there. My kohler command has the carb on the front of the engine not on top.
Link to comment
Share on other sites

Mine is straight also. But think if you have a cab it may give you a little more room around the cab support. Mine is very tight in that spot.
Link to comment
Share on other sites

It looks twisted. Use a large adjustable wrench or a pipe wrench to twist it back where it should be. This may make it straight also. If you take it off, you can probably clamp it in a vice and straighten it.
Link to comment
Share on other sites

Guest
This topic is now closed to further replies.
×
×
  • Create New...