46in Dozer blade angle rod

[mowerman1193 0]

Is the rod all one peice or is it a two peice..It kinda looks like a two piece deal in the parts book but I have been looking for a one peice..A local parts guy says he has one but he sends me out to a pile of lift/control rods thats knee deep..Problem is I dont really know what I am looking for,LOL Also I need the bracket for my 3415H that bolts to the tractor to hold the rod in place..Anyone know if that part is the same as the old 9hp Landlords style? I don't see any holes in the side panel to mount that bracket..Anyone have a picture of that part and where it goes? Thanks,

[ambler 0]

download the 7100 attachments parts manual. You can still buy it new.

[mowerman1193 0]

quote:

---

Originally posted by ambler
download the 7100 attachments parts manual. You can still buy it new.

---

I know that..But $60 shipped for a 4ft. rod is a little pricey when the guy at the salvage yard says he has one for $10..I just need to know what it looks like...For much over $10 I will make one.. As for the bracket..well I have no clue on that as well as I have never seen one..other than the one on my old 9hp Landlord..But I would assume they are different..

[Mack 1]

Here's a pic. UCD posted awhile back.It's for a Homelite but should give you a good idea of what you need.

[ambler 0]

A drawing of the bracket is in the parts manual. This homelite picture is not it. It kicks off the frame.

[UCD 14]

Ambler The Homelite setup is the same except for the handle support bracket the picture just dosen't show it clear where it connects at the plow. Here is a cleaned up diagram of the 46" plow angle control. You will also need the pivot joint (fork Assy.) Part# 106131. It is still available.

[mowerman1193 0]

Thanks Maynard, Thats what I was looking for..My manual doesn't show a very good diagram...