Belt info needed

[ehertzfeld 1]

I'm looking for the lenght of belt part number 122146 it's the starter belt for a 2210. I have look at the chart that Maynard posted, but it's not listed.

Thanks for any help, need to finish this project!:D Elon

[BLT 717]

Go here. http://www.simpletractors.com/parts/belts/belts_(pg17).htm

[PhanDad 3,534]

Kent lists it on his site, it's 38" long with a No 2 cross section (4L - 1/2 x5/16).

[UCD 14]

a NO 2(4L)cross section belt is 1/2" x 9/32" the closest current (4L) belt is part# 1719381 Length 37.62 I believe belt# 122146 is nla Elon: what is the application?

[ehertzfeld 1]

quote:

---

Originally posted by UCD
a NO 2(4L)cross section belt is 1/2" x 9/32" the closest current (4L) belt is part# 1719381 Length 37.62 I believe belt# 122146 is nla Elon: what is the application?

---

Well it all started when I wanted to get a sickle bar! lol this if for Rob's B12, he pulled a engine out of his 2210 and wants to put it into the b12. The I had to swap the pullies as well. Doing so made the two belts that were on each engine the wrong size. One is too long and one is too short. "story of my life!" lol. I figured if I get the right belt for the 2210, I can go from there. I'm sure with all this snow Rob is dying to use his blower! Well thanks for all the info. Elon

[UCD 14]

You still didn't tell me what it is for. The starter belt hydro belt what? and what pulleys did you swap and why?

[toad270 15]

call local simplicity dealer for the belt or new number or take it to local Napa store to get a measurement of the belt Napa can crossrefence the belt number they just did it for me for a hydro belt for B-110

[ehertzfeld 1]

quote:

---

Originally posted by UCD
You still didn't tell me what it is for. The starter belt hydro belt what? and what pulleys did you swap0 and why?

---

Oh geeze your right! sorry. The belt is for the starter/generator. The pulley is the one that bolts to the flywheel. They must be differnt cause they didn't match up. I started this awile ago so I really do not remember why they didn't match up. I just couldn't get the drive shaft to line up. As soon as I switch pulleys, it lined up nicely. Elon

[UCD 14]

One engine uses spacers the other doesn't. The 12hp would have a hydro pulley on it the 10 hp wouldn't B12 belt# 157524 Length 39.1 type 3/8 cross section 3/8 wide x 19/64 thick 2210 belt# 1607323 length 37.5 type 3/8 cross section 3/8 wide x 19/64 thick