Wiring, gas line, etc routes for 2110

[TomMaryland]

Hi all, Yes I forgot to take pics of this stuff before I tore it down to resotre! argggggggg B) Before I go fumbling around for a long amount if time...I thought I'd come in and ask the pros: 1) Can anyone tell or show me the routing for wiring on my 2110? 2) Also, what route does the gas line take? 3) How about the throttle and choke cables? Many thanks in advance! I'll have pics maybe today...decals are on, painting is done. Just have one more innertube to put in a rear tire.

[toad270]

Start by looking here 2110 with manual lift is manufacter number 990432 http://www.simplicitytechpubs.com/6767PRINT/PDF_files/TP_400_1319_01_LL_S.pdf

[TomMaryland]

Thanks, Todd. I've got a hydraluic lift, but that manual covers that as well.. It does show some of the wiring and hows its routed. I'm looking for the gas line and choke routings, and the gas line too. Anything on that?

[Kent]

I have no clue if this is the correct routing, but this pic of my Big Ten might help... http://simpletractors.com/images/big10_delux/Dcp00302.jpg I don't seem to have a closeup of that side to show...

[TomMaryland]

Thanks Kent. I can see where the gas line routes with the one. I think I see the choke line clamp, back behind the intake, two clap, top or bottom. I have a line clamp sitting here and I think itd the throttle cable clamp. Has a 90 deg bracket, 1/4" hole in it. Does this one go up above the carb, into the side of the head?

[Kent]

I'm not sure I understand the bracket in question. Is it the one that holds the linkage for the governor, as shown on the left below? [img]http://simpletractors.com/images/300401/fig_5.jpg[/img] If not, I'd guess that it simply bolts into the side of the bulkhead in one of the two blind nuts, down below the dash sheet metal on the side that hides the gas tank...

[TomMaryland]

Nice diagram there, Kent! It looks like its the one in the left diagram up where the cable turns straight down. I think thats where this clamp goes. Theres a 1/4-20 tapped hole right near the top bracket the has the gov rod going through it. It looks like this clamp bracket ( the only one I have leftover ) bolts into that 1/4-20 hole and the cable clamp is attached to the bracket.

[Kent]

Now that you remind me, at least one of my tractors did have a very small bracket up there to hold the throttle cable....

[ambler]

Tom I believe the wiring comes out under the gas tank shelf to the engine compartment next to the regulator. I can take pics of my B110 if you need it. Do you have lights?

[TomMaryland]

I think I got the little throttle cable bracket on right last night. Wiring doesn't look too bad. I'm using the two clamps on either side of the battery/gas tank frame bulkhead. Yes Ambler, I have lights for it, any suggestions there?

[ambler]

My B110 light wiring has two three way connectors the first by the pad that holds up the misddle of the hood by the regulator. feed comes from light switch to this three way one wire goed forward to the split for the two headlights, the other goes back under tanl to the work lamp.