316H FDT

[Mack 1]

Finally got the last piece needed for my project tractor.Went to an inventory reduction auction at a Cub Cadet dealer and found this setting half hidden.Waited patiently and was rewarded by getting it for $60.00. :D

Added to this -

And this -

+ a little warm weather to get some work done in the shop = this :D:D:D

[MDB 134]

I can tell that is going to be one fine FDT:D, keep us posted Mack, Can hardly wait to see it finished.:D

[Chris727 1,912]

Sounds like a great deal on that engine!

[D-17_Dave 12]

Mack, it looks as if your in about as deep as I am.lol ood luck and I can't wait to see the finished product.

[Mack 1]

Long stalled project showing progress today!Got the BGB changed and the hydrostat trans mounted up.

[comet66 0]

Heck of a deal on that engine! That's going to be one nice tractor.

[maxtorman1234 0]

You got a great deal on that motor, looks like a new carb too. Can't wait to see the finished product,

[Mack 1]

Well,just getting the side transmission plates switched over off a non 300/400 A/C Vickers slowed me down.Plus the Variable speed Bevel Gear Box had to be changed off from a Shuttle drive took more time than I wanted. Maybe,if I can stop picking up other "cases".This project will get done very soon.;)

[Mack 1]

[Ryan 0]

Looks great. Looks like a lot of fun.

[comet66 0]

That's really shaping up nice Mack!

[PeppyDan 3]

Looks great Mack, I'm looking forward to seeing it at the Wapak show this year. Dan

[MarkM1958 1]

IMPRESSIVE!!!