Any tips on chainging deck bearings

[Nick 0]

What's the best way to get the shafts on the mower deck to stop spining so I can loosen the nuts so I can change the bearings?

[RayS 79]

Put the side that the blades goes on in a vise.

[KVANDY12 0]

Air impack wrench is best if you have one. If not with the blade on put a 2x4 so the blades can't turn and wrench them off. that is if they are still on the deck. If not clamp the shaft in a vice and go to work on them.

[Nick 0]

Thanks Ray & Ken. I was not aware you could pull the shafts in one piece from the deck and put them in a vise. I did that last night.