Randyny Posted June 1, 2005 Posted June 1, 2005 Funny, after rallying behind my Kohler motor in another post, I now get no spark while cranking. Take plug out and crank - no spark. Turn key from run to off - I get a spark. Tells me the coil & condensor are fine. I'm going to tinker around, probably a bad onnection somewhere. Can anyone shed some light on this problem?
powerking_one Posted June 1, 2005 Posted June 1, 2005 I would get out the DVM (digital volt-ohm meter) and start troubleshooting it. Tom(PK)
Randyny Posted June 2, 2005 Author Posted June 2, 2005 Five minutes of troubleshooting revealed some moisture on the points. Makes sense based on the symptoms. Beware of the power washer....
HubbardRA Posted June 3, 2005 Posted June 3, 2005 Make sure the ignition is connected to the ignition terminal and not the accessory terminal. The ignition terminal stays on in start position. Accessory terminal is cut off in start position, but is energized in the on position.
Recommended Posts