36" single belt snow thrower

[TOMT 0]

I am looking for the drawing showing the belt routing for this snow thrower. Any assistance would be greatly appreciated.Also need belt length & cross section. thks, Tom

[cwm1276 11]

Tom, I'll ask first What tractor is this snowblower on? The blower itself fits many tractors, depending on the hitch.

[TOMT 0]

I'm putting the snow thrower on a Simplicity 3210V. Is there a mounting diagram?? Thanks in advance, Tom

[UCD 14]

[Wishin2BMowin 0]

Lot's of luck...When I got my 3212H the blower it had no belt on it. Got a new one but it took me quite a while to get it on correctly. The thing twists and turns and if you don't get it on correctly the blower turns the wrong way! I suggest starting with a new belt and keep the old one for a spare cause blowers get clogged up with stuff and the belt sure takes a beating! Also make sure the front PTO pully set screw is tight where it goes on the engine shaft. Mine got loose while I was using it last Winter and it went rolling away in the snow! Must have been funny to watch me digging around in the snow to find it but I did!

[TOMT 0]

Thanks alot !! Do you know the belt length & width?? Tom

[Wishin2BMowin 0]

I think it's around 56 inches long and 1/2 wide if it's the same as my 3212H with a 42 inch blower?

[TOMT 0]

Thanks again !! I'm going to attempt putting it on the tractor. Tom

[RayS 79]

Read this post you can download a manual from Simplicity website. It`s the same blower as yours. http://simpletractors.com/club2/topic.asp?TOPIC_ID=55307

[roma3112 0]

Fellas Just a bit off topic, but i am getting ready to mount my snowblower for the Boston snow season :( I had a brain fart and was wondering which hole the idler pulley goes into for the blower. I know there is 1 hole for the mower and 1 for the blower they are one ontop of another and right now I have the idler on the top hole; is this the correct one? thanks john

[RayS 79]

On my 917H the top one is going to the mower deck. The bottom must go to the blower.

[AC@deerfield 0]

lol ..... I had the same problem last winter .... placed the blower idler on the lower setting and took a digital picture of it !!

[goatfarmer 817]

If the 3212 is like my 2110,make sure you have the 2 fingers that go on each side of the drive pulley.They are belt guides,and it'll keep throwing the belt without them.

[MazdaManiac 0]

Again, a little off the topic, but what the heck. I've got a 36" blower for my 3210V, but I managed to smash the idler pulley. Thing is, for some reason the idler pulley I smushed is 5 1/2" in diameter compared to the 4 1/2" diameter pulley that is standard. I put the 4 1/2" pulley on my tractor, but even after adjusting it the belt slips. My Simplicity dealer can only find a cast iron pulley that is 5 1/2" in diamter for just over $30. Does anyone know of any place I could find a steel pulley? I'm thinking it might be cheaper to buy a new belt? Thanks, Bob