Frustrating Electrical

[Brucep 0]

Does anyone have an electrical diagram for a 7016 MFG# 1690423 16 horse? I have a service and repair manual that list my tractor as one of the models covered yet in the electrical section they don't show a diagram for mine. The diagram starts at 1690474 and my tractor is 1690423. If it listed them starting at a lower number with mine in between then I would assume mine is the diagram shown but they don't. Has any one else had this problem? I can't find a diagram in the tech pubs either. This book wasn't cheap, and it leaves a lot to be desired. This isn't the first thing I have ran into with it.

[Mack 1]

From the owner's manual at tech pubs.

[Brucep 0]

Thanks Mack. I went back into the tech pubs to see if I could find out where you found it. It was under operators manual (100). Don't know why it wasn't under electrical also but any way. Guess I try to keep it simple figuring they would too. Thanks again!

[SmilinSam 3,940]

Just for fun here is the diagram for an earlier 7016 using the starter generator rather than the flywheel starter... [img]http://a3.cpimg.com/image/DB/9B/8901083-5e9b-01930200-.jpg[/img]

[Brucep 0]

I had one similar to that from when I had my old 3410 with a starter generator.

[Mack 1]

If you know the Mfg#,I find it's easier and a lot quicker to enter it at this link to find what's available. http://www.simplicitytechpubs.com/techpubsearch.php

[Brucep 0]

Great! Thanks Mack.

[UCD 14]

Mack The only problem with the  [url="http://www.simplicitytechpubs.com/techpubsearch.php#start"]Tech Pubs site [/url]  is that not all manuals listed there are available for download and not all manuals available are listed. Granted the  [url="http://www.simplicitytechpubs.com/v_techpubsearch.php"]Tech Pubs vendors site [/url]  is harder to use but if the directions for  [url="http://www.simpletractors.com/club2/topic.asp?TOPIC_ID=32436"]Simplicity Technical Publications Document Search[/url]  on how to use the  [url="http://www.simplicitytechpubs.com/v_techpubsearch.php"]Tech Pubs vendors site [/url]  that I have posted are followed it only takes a couple min. to find any manual you want if it is on the site.

[Brucep 0]

I usually do good with the tech pubs site. My problem is sometimes what I am looking for isn't where I think it should be. I'll just have to take the time to look into other places within the site.