Jump to content

Unofficial Home of Old Simplicity & Allis-Chalmers Garden Tractors

Sign in to follow this  
bigdog46

Wiring schematic for Briggs 243431 engine

Recommended Posts

bigdog46
I have a Briggs & Stratton 10hp cast iron engine from a Simplicity 3210V Landlord that came in pieces. It is a model 243431. I need a wiring schematic in order to properly put it back together. Can any of you guys help? Thanks in advance. Gary.

Share this post


Link to post
Share on other sites
bigdog46
Thanks, this diagram will be very helpful when I put the engine back into the tractor. But what I really need right now is a wiring diagram for the engine itself. Where the wires go from the magneto, points, etc. Thanks for any help you can provide. Gary.

Share this post


Link to post
Share on other sites
HubbardRA
GB, Basically everything is in the diagram above. The points, which are not shown, hook to a wire that goes to the magneto coil. The other wire, coming out of the magneto, or if there is none, then a second wire also hooked to the points, is grounded to kill the engine. This is the white wire shown in the diagram above, which grounds to the chassis when the ignition switch is turned off. If you try to run the engine off the tractor, just leave that wire hanging free, and then ground it when you want to shut off the engine.

Share this post


Link to post
Share on other sites
Guest
This topic is now closed to further replies.
Sign in to follow this  

  • Who's Online (See full list)

    • SmilinSam
    • simplewrench
    • John Dyer
    • spi
    • bowhunt4life
    • goatfarmer
    • smalljob
    • Bill725
  • Today's Birthdays

    1. Briggs
      Briggs
      (53 years old)
  • Recent Status Updates

    • Paul M.Murphy

      Paul M.Murphy

      Hello glad I got on this site. I hope to upload a couple of photos of my Simplicity Broadmoor 
      Model 707 Tractor. I have replaced all the belts on it and installed a new ignition switch.
      Have a mower deck which was in poor shape , repaced a couple of bushings and welded the
      deck where there was some holes. The tractor and mower deck came from a friend and the 
      mower deck metal was getting pretty thin. Some new metal was put in it and we also undercoated the underside of the deck. This was done by my friend Greg Toulman.
      I have not put the mower deck on the tractor yet, waiting for Greg to come home and give me a hand. Can you please tell me if there is a manual for the mower deck and where I could get one.
      I would also like to get some moon wheel discs as well.
      I will try and down load some photos of the tractor when my wife shows me how to. 
      I really love driving this tractor and also how well it is made compare today's tractors, especially the flexible rear end and the rollers.
      Tell the next time 
      Paul
       
      · 8 replies
    • jbrooks

      jbrooks  »  Talntedmrgreen

      Josh
       
      folowing  this from a link at the downloads.  I just rescued an AC 920 with the lambodini diesel. I can' t download  yet .  Where did you find the PDF copy you posted. . I would like to figure out how to adjust the injection pump. 
      I assume it's a bosche, correct
      · 0 replies
  • Adverts

×