Jump to content

Unofficial Home of Old Simplicity & Allis-Chalmers Garden Tractors

What size or # is the PTO drive pully on a 6216?


Recommended Posts

Posted
Looking for the size or part number for the PTO drive pully W/ setscrew? Thanks Chris
Posted
Chris if it is the pulley that goes on the trans it is 4 inches in diameter. i bought one at the hardware and it worked ok but was a little to wide, then sandylake equipment found me a nos. one i need to put it on
Posted
The PTO(deck) drive pulley off the engine on mine is 4 3/4 inches but it has no set screw. The one on my 6211 is also 4 3/4" and the drive belt pulley is 3". I hope this helps or tell us where the pulley is?
Posted
Go to the home page and on the right side in the box where it says Search for Manuals at Simplicity Mfg. in the box to the right of MFG NO: insert MFG# 1690688 or 1691035 and down load the parts and operators manuals for it. You will need Adobe reader installed in your computer. Adobe Acrobat Reader is required to view the PDF documents and can be downloaded free from Adobe [url="http://www.adobe.com/products/acrobat/readstep2.html"]here[/url] After you download the file and adobe opens it on the left side in the tool bar click on save a copy and save it to your computer.
Posted
Sorry - should have been more specific - The rear PTO(for the Tiller)pulley and has a set screw - Sorry for the slow response - Newspaper person took out me and my F150 - All is good -
Posted
More specific - The pulley that mounts to the BIG pulley on the same rod as the tranny - Still trying to get the old on off a new purchase without doing the whole dismantle thing - Thanks Chris
Posted
part # 1666282 4inch diameter 1/2inch wide belt 0.625 bore 3/16 inch keyway
Posted
I come up with part #170395 which is NLA but is 4" like Steve pointed out.
Posted
Thanks for all the help - Chris
Guest
This topic is now closed to further replies.
×
×
  • Create New...