Bear 46 Posted October 30, 2000 Will a trans from a 6011 fit a 6010 Simplicity? Any suggestions on how to get rims off of the rusted axles? Share this post Link to post Share on other sites
JeffNemes 1 Posted October 30, 2000 I believe they will interchange - also check the axle sizes if you don't also have the rims. I think they went from 7/8 to 1". You will probably need to heat it up to a real "well done" with a torch. Share this post Link to post Share on other sites
Bear 46 Posted November 7, 2000 Thank you Jeff the axles were different. By heating them up we got them off without damaging the rims. Now here is how we did it. We put it in a 55 gallon barrel and slid two bar stocks underneith the rim of one wheel. Next we heated the rim housing on the axle and took a big bar and stuck it down the shaft of the rim housing and hit it with a maul. They both came out that way. Thanks again. Share this post Link to post Share on other sites
JeffNemes 1 Posted November 8, 2000 Very good Bear! One of my guys also suggested welding a 5/8 nut onto the outside of the rim and using a 12" bolt and impact if they get real onery! Share this post Link to post Share on other sites