Finally got my hydro lift ram.

[Mat Perucci 0]

The one I had leaked and had no power and was badly pitted. Heres what i found to replace it.

paid $112 for it on ebay.

[UCD 14]

Mat Rename your picture file (lift ram #1) with out the spaces or symbols I.E.# Then reupload it.

[Mat Perucci 0]

ok thanks for the tip

[Scott Salmons 7]

I probably could have made you a new shaft. What diameter are they? I make a lot of hydraulic shafts at work.

[Mat Perucci 0]

Scott, Ill take the other one out sometime this week. If you would like to duplicate one that would be great. Also the original ones arent chromed so if you could get them chromed too that would probably make it much better. Ill get back to you with the specs.