oldstuff619 Posted January 29, 2007 Share Posted January 29, 2007 Hi I am a new member to this grate club dose any one know the shipping weight of a cckb motor thanks Bruce Link to comment Share on other sites More sharing options...
BLT Posted January 29, 2007 Share Posted January 29, 2007 Try this: Specifications on Electric Start CCKB-MS/1 Onan Engine: Nominal Dimensions: Height......................................... 22 in. Width.......................................... 20.5 in. Length......................................... 15 in. Approximate Weight in pounds....................... 172 Fuel ........................................... Gasoline Number of Cylinders ............................... Two Cylinder Bore ..................................... 3.25 in. Cylinder Stroke ................................... 3.00 in. Cubic Inch Displacement ........................... 49.8 Compression PSI (sea level) ....................... 100-120 Maximum BHP at 3900 rpm ........................... 20 Cooling Air Volume (cfm) at 3600 rpm (Pressure Cooled) ............................. 975 Governor Type ..................................... Adjustable, mechanical flyball Fuel Pump Type .................................... Diaphram Fuel Pump Lift .................................... 4 Feet Lubrication System ................................ Full Pressure Oil Capacity (U.S. quarts) ........................ 3.5 Optional Oil Filter Capacity (U.S. quarts) ........ 0.5 Standard Power Take-Off Shaft Dimensions: Length ........................................ 2.75 in. Diameter ...................................... 1.5 in. Keyway Length ................................. 2.13 in. Keyway Depth .................................. 0.38 in. Keyway Width .................................. 0.38 in. Ignition .......................................... Battery Tune-Up Specifications: Breaker Point Gap (Full Separation) ............... 0.020 in. Spark Plug Gap .................................... 0.025 in. Ignition Timing ................................... 20 degrees BTC Carburetor Float Clearance (between float bowl gasket and float) ......... 0.13 - 0.19 in. Link to comment Share on other sites More sharing options...
oldstuff619 Posted January 29, 2007 Author Share Posted January 29, 2007 thanks Bob this will help on finding a shipping cost to Michigan from eastern mass Link to comment Share on other sites More sharing options...
eagle5473 Posted January 30, 2007 Share Posted January 30, 2007 All I know is that they are very heavy to lift out of a tractor by yourself I did it a few times and now have an engine hoist!!!!!! 172 sounds about right Link to comment Share on other sites More sharing options...
Recommended Posts