hydrolic desn't work

[samson 1]

I tried the hydrolic lift with the pump in the vice and a 1/2" drill hooked to the shaft. I tried it every which way and it does not pump oil at all. What would be my next step?

[MPH 12]

You say you tried every which way, is that meaning you had the drill in reverse too? These are counter rotating units. Been there done that the first time I tested one with a drillB)

[Willy 2]

Ck you relief valve,you may have a broken spring or something stuck under the seat. The pump is almost Murphy proof,in 30+ years the only time I've ever had to take one apart was because it was leaking. It's the easiest thing to ck,and usually just takes a little cleaning. Good luck.
[img]/club2/attach/Willy/Watching.jpg[/img]

[samson 1]

I finally found out from BLT that it runs counterclock wise. Cleaned every thing up. And it works. nEXT qUESTION, does the later model pump fit on a B12?

[RayS 80]

quote:

---

Originally posted by samson
I finally found out from BLT that it runs counterclock wise. Cleaned every thing up. And it works. nEXT qUESTION, does the later model pump fit on a B12?

---

The round and square resovoir pumps will fit all the B series tractors.

[samson 1]

Thanks Ray, Blt. willy and Mph. Every question is solved and the hydro is working perfectly. I am going to test the pressure with a set up like MPH did.