Jump to content

Unofficial Home of Old Simplicity & Allis-Chalmers Garden Tractors

Sign in to follow this  

Two 4211H's Question

Recommended Posts

I Got two 4211H from a retired gentalman that sat in the woods for 9 years. I learned something about the straight 4211 and the H. The H model has 1'' diam keyed axles and the other has 3/4" axels. I had to cut one of the rims off as it was rusted on so tight that I had to use a torch to get it off. NOW! the rims apperently are discontinued as I went thru all the dealers on our site (jacks small eng etc.) There is a pair on Ebay off of a 5216h That Tom schmit told me about. He seems to think they will fit. Any help? To my surprise they both run good. But don't compare to the B models.

Share this post

Link to post
Share on other sites
Roger, what part number did you come up with for the wheels on the 4211H? I came up with #1673347 which is now #1673347SM. It shows to still be available at Jack's for $58.39, eight inch wheel seven inches wide. The wheel from the 5216H shows as a different part number and is a ten inch wheel six inches wide.

Share this post

Link to post
Share on other sites
Gregc Thats not it, I get the no. 1669965 The rim measures 9" 0ut side The tire is 18X950. 8. This is only for the 4211H. I know the 5616 wheel is 10", but its 1" KEYED SHAFT so if the shaft is 3 3'4 it woulf fit, just be alittle bigger tire and rim. The D Wiedle that is selling them says he doesn't have the rims there to measure so I would be buying a pig in a poke. Its a nightmare!!

Share this post

Link to post
Share on other sites
This topic is now closed to further replies.
Sign in to follow this  

  • Who's Online (See full list)

    There are no registered users currently online

  • Today's Birthdays

    1. Mike_H
      (43 years old)
  • Recent Status Updates

    • Paul M.Murphy

      Paul M.Murphy

      Hello glad I got on this site. I hope to upload a couple of photos of my Simplicity Broadmoor 
      Model 707 Tractor. I have replaced all the belts on it and installed a new ignition switch.
      Have a mower deck which was in poor shape , repaced a couple of bushings and welded the
      deck where there was some holes. The tractor and mower deck came from a friend and the 
      mower deck metal was getting pretty thin. Some new metal was put in it and we also undercoated the underside of the deck. This was done by my friend Greg Toulman.
      I have not put the mower deck on the tractor yet, waiting for Greg to come home and give me a hand. Can you please tell me if there is a manual for the mower deck and where I could get one.
      I would also like to get some moon wheel discs as well.
      I will try and down load some photos of the tractor when my wife shows me how to. 
      I really love driving this tractor and also how well it is made compare today's tractors, especially the flexible rear end and the rollers.
      Tell the next time 
      · 8 replies
    • jbrooks

      jbrooks  »  Talntedmrgreen

      folowing  this from a link at the downloads.  I just rescued an AC 920 with the lambodini diesel. I can' t download  yet .  Where did you find the PDF copy you posted. . I would like to figure out how to adjust the injection pump. 
      I assume it's a bosche, correct
      · 0 replies
  • Adverts