Jump to content

Unofficial Home of Old Simplicity & Allis-Chalmers Garden Tractors

Sign in to follow this  
Guest

Snowthrower Ajustment?????

Recommended Posts

Guest
My snowthrower #2025082 36 inch as no ajustment for the #40 chain (if one I don't see it) even if I put the chain shorter the tension is not right,the gear are wear out after those years I understand but before I make a idle or tensionner or..... if you have a better idea let me know. Thank to all Don.P

Share this post


Link to post
Share on other sites
Guest
Thank you Dutch, Yes Bill you are right, it's the bolt the one I did'nt see because something at -20 outside you work fast and you to take all the attention thank you very much again. Don.P

Share this post


Link to post
Share on other sites
Sandy_Lake_Imp
I am at home now & don't have a reference but I thought the drive shaft across the rear was moveable fore & aft on each end. If my memory fails me it won't be the first time- nor the last!!! Bill Klein

Share this post


Link to post
Share on other sites
DoubleT
Is the chain jumping off? Are the shaft bearings okay? Auger bearings? Sometimes you can compensate for worn sprockets by using an offset (1/2) link.

Share this post


Link to post
Share on other sites
Guest
This topic is now closed to further replies.
Sign in to follow this  

×