2burning 1 Posted June 14, 2007 Ok, I am sure this should be an easy question to answer for the FDT crowd... The shaft that holds the center pto on, what keeps it in place, just the one cotter pin? Does the cotter pin fit right between the frame and the PTO, so the shaft can't move back and forth too far? If not, what keeps the shaft from sliding around? I think if I had a shaft I could figure it out, but all I have is the picture: Thanks! Share this post Link to post Share on other sites
toad270 15 Posted June 15, 2007 I'm not sure what you are working on but the cotter pin does go between the frame and the pto on my early B-10 not to much room so it doesn't move to much. Share this post Link to post Share on other sites
2burning 1 Posted June 15, 2007 Thanks, that's exactly what I needed to know! Share this post Link to post Share on other sites