Jump to content

Unofficial Home of Old Simplicity & Allis-Chalmers Garden Tractors

Sign in to follow this  
Bunky

Model 19 Carburetor Help??

Recommended Posts

Bunky
I have a Model 19 briggs and the Carb or linkage is not right, Throttle wouldn't open and close all the way when I got it So I had a parts motor and took the rod off the Gov, arm and changed it, Well now the throttle shaft won't close... Here's what I have for an intake elbow,
[img]/club2/attach/Bunky/DSCN1620.JPG[/img]
and here are the 2 rods, the one on the left (approx 6 1/2 ") is the one off the parts motor and the other is the one that came with the engine and it's all bent out of shape and shorter then the one on the left.. The Gov arm moves approx 3/4 off an inch... Can some one tell me if I have the right rod and intake elbow?? or what I need...
[img]/club2/attach/Bunky/DSCN1621.JPG[/img]
Any help would be appreciated...

Share this post


Link to post
Share on other sites
HubbardRA
Push the throttle on the carb to WOT position. Push the governor arm to WOT position. Hold the two in that position and made a rod that fits the holes. That is the length you need. A metal coat hanger works fine. I have made several linkages this way. Both tractors that I took to Spring Fling had these homemade linkages and several people can verify that they ran good (when there was fuel in the tank).

Share this post


Link to post
Share on other sites
Guest
This topic is now closed to further replies.
Sign in to follow this  

  • Who's Online (See full list)

    • Snojetter
  • Today's Birthdays

    1. Andust
      Andust
    2. Noly
      Noly
      (69 years old)
  • Recent Status Updates

    • Paul M.Murphy

      Paul M.Murphy

      Hello glad I got on this site. I hope to upload a couple of photos of my Simplicity Broadmoor 
      Model 707 Tractor. I have replaced all the belts on it and installed a new ignition switch.
      Have a mower deck which was in poor shape , repaced a couple of bushings and welded the
      deck where there was some holes. The tractor and mower deck came from a friend and the 
      mower deck metal was getting pretty thin. Some new metal was put in it and we also undercoated the underside of the deck. This was done by my friend Greg Toulman.
      I have not put the mower deck on the tractor yet, waiting for Greg to come home and give me a hand. Can you please tell me if there is a manual for the mower deck and where I could get one.
      I would also like to get some moon wheel discs as well.
      I will try and down load some photos of the tractor when my wife shows me how to. 
      I really love driving this tractor and also how well it is made compare today's tractors, especially the flexible rear end and the rollers.
      Tell the next time 
      Paul
       
      · 8 replies
    • jbrooks

      jbrooks  »  Talntedmrgreen

      Josh
       
      folowing  this from a link at the downloads.  I just rescued an AC 920 with the lambodini diesel. I can' t download  yet .  Where did you find the PDF copy you posted. . I would like to figure out how to adjust the injection pump. 
      I assume it's a bosche, correct
      · 0 replies
  • Adverts

×