mikew Posted July 10, 2007 Posted July 10, 2007 hi. I have a 63 B10 with a mower deck but no pulley system for the mower drive belt. I believe the belt goes to the mid pto pulley but I don't know what it uses to engage or disengage the belt. It also has to change the belt from vertical to horizontal. any help on what it looks like or where i can get a pulley setup would be appreciated
Kent Posted July 10, 2007 Posted July 10, 2007 Start here, to understand how it mounts on the tractor. http://www.simpletractors.com/operation/42_mower/42_rotary_mower.htm There are 3 belts, total, involved: 1. One goes from the bevel gearbox to the power take-off to drive it 2. One goes from the power take-off to the center arbor on the mower deck to drive the center arbor 3. One goes from the center arbor on the mower deck to the two outside arbors to drive them
mikew Posted July 10, 2007 Author Posted July 10, 2007 thanks kent. i appreciate the reply. after looking at that, maybe I don't have the side mount pto that i need. I have a pulley directly opposite the drive pulley, probably the other end of the same shaft, that i assumed it went on but it doesn't seen to be low enough for the belt to clear the tractor
Recommended Posts